
Offizielles LAUNCH Europe Produkt
24 Monate kostenlose Updates
Deutscher Experten-Support
30 Tage Geld-zurück-Garantie
34 Service Functions
-
Service function for bleeding brake systems equipped with ABS.
-
Basic setting of the EGR valve after replacement or cleaning.
-
Reset of urea values (AdBlue) after replacement or refilling.
-
Adaptation of air/fuel mixture parameters.
-
Reset of SCR catalytic converter adaptation values and reinitialization of the NOx sensor.
-
Basic setting of adaptive front lighting systems after replacement or repair.
-
This service function allows you to enable or disable the transport mode.
-
Software for registering a new starter battery. The control unit must be informed that a new battery with full capacity has been installed. This allows the battery management system to work optimally and charge the battery according to its performance.
-
Deactivation of the automatic engine shut-off or hiding of the Start/Stop warning light.
-
This function is used for testing and diagnostics of the high-voltage battery. In particular for comparing charging history, reading battery status, or commissioning the high-voltage battery.
-
Basic setting of the throttle body after cleaning or replacement.
-
Adjustment of the electric seat positioning with memory function after replacement or repair.
-
Software for brake reset and parking brake basic setting during brake system maintenance.
-
Calibration of air suspension systems after replacing sensors or the control unit.
-
Initialization of window regulator motors and restoration of the automatic function.
-
Reset of transmission adaptation values after an oil change or repair.
-
The A/C system initialization must be performed when the control unit or actuator is replaced, or when the control unit memory has been lost.
-
This service function allows you to store the injector calibration codes in the engine control unit.
-
This function is used for calibration after the adaptive cruise control module has been replaced or repaired.
-
Relearn of the clutch position after replacement.
-
Relearn of the crankshaft position sensor after replacement.
-
Activation of the water pump to bleed the cooling system.
-
Basic setting of the steering angle sensor after replacement or wheel alignment.
-
This function allows you to relearn the angle position sensor/rotor position sensor if its memory is lost or the sensor has been replaced.
-
If the particulate filter is overloaded, fuel consumption increases and engine power decreases. This service function allows you to perform a regeneration of the gasoline particulate filter.
-
The software allows you to read and register tire pressure sensor IDs in the control unit.
-
Basic setting of the zero position of tilt and slide sunroofs.
-
Anpassung der Ladedruckregelung nach Tausch oder Instandsetzung.
-
Relearn of immobilizers and transponder keys.
-
Reset of oil service and inspection intervals. Long-life service is also supported.
-
Monitors the crankshaft acceleration during each cylinder's power stroke to determine the relative performance of each individual cylinder.
-
Anpassung des Reifenumfangs nach einer Änderung der Raddimensionen.
-
Change of the system language on the vehicle's on-board computer.
-
Personalisierungseinstellungen für versteckte Komfort-Funktionen.
Europäische Fahrzeugmarken
-
ASTON MARTIN
-
AUDI
-
BENTLEY
-
BMW/MINI/ROLLS-ROYCE
-
BUGATTI
-
CITROEN
-
DACIA
-
FERRARI
-
FIAT/ABARTH/LANCIA/ALFA ROMEO
-
IVECO
-
JAGUAR/LAND ROVER
-
LAMBORGHINI
-
MAN TGE
-
MASERATI
-
MERCEDES-BENZ/MAYBACH/SMART
-
MERCEDES-BENZ CV
-
OPEL/VAUXHALL
-
PEUGEOT
-
PORSCHE
-
RENAULT
-
ROVER
-
SAAB
-
SEAT
-
SKODA
-
VOLKSWAGEN/VW NUTZFAHRZEUGE
-
VOLVO
Asiatische Fahrzeugmarken
-
ACURA
-
DAIHATSU
-
DAEWOO
-
FUSO
-
GENESIS
-
HONDA
-
HYUNDAI/HYUNDAI PLUS
-
INFINITI
-
ISUZU
-
KIA/KIA PLUS
-
MAHINDRA
-
MARUTI
-
MAZDA
-
MITSUBISHI
-
NISSAN
-
SSANGYONG
-
SUBARU
-
SUZUKI
-
TOYOTA/LEXUS
Amerikanische Fahrzeugmarken
-
CHRYSLER/JEEP/DODGE
-
FORD/LINCOLN
-
FORD (EUROPE)
-
GM/BUICK/CADILLAC/CHEVROLET
-
GM (BRAZIL)
-
HOLDEN (AUSTRALIA)
Chinesische Fahrzeugmarken
-
BAIC
-
BORGWARD
-
BRILLIANCE
-
CHANGAN
-
CHANGHE/CHANGHE SUZUKI
-
CHERY
-
FOTON
-
GONOW
-
GWM
-
HAFEI
-
HAIMA
-
JAC/JAC REFINE
-
JINLONG
-
JMC
-
JOYLONG
-
LUXGEN
-
MAXUS
-
MG/ROEWE (SAIC)
-
SGM
-
ZOTYE
-
ZX AUTO
Russische Fahrzeugmarken
-
GAZ
-
VAZ
Complete system diagnostics with bidirectional control
The all-round diagnostic device for ambitious users
35 service functions
From oil service reset to DPF/GPF regeneration and brake bleeding to TPMS, AdBlue reset and high-voltage battery diagnostics - all relevant maintenance tasks in one device.
DoIP & CAN-FD protocols
Modern protocols enable up to 6x higher data rates than classic CAN - this saves time in complex diagnostics and flash applications.
Remote diagnostics via TeamViewer
For complex diagnoses, specialists can control your device via TeamViewer from any PC - no matter where you are.
Intelligent diagnosis
Automatic FIN/VIN recognition with integrated DTC library for quick problem identification without technical expertise.
Leistungsstarke Hard- & Software
The CRP 919S offers a professional diagnostic platform with a 7-inch touchscreen and Android 10.0:
Here's what you'll get:
Complete package in a transport case
Included in the delivery:
- ✓ CRP 919S Diagnostic Device
- ✓ 16-pin OBD-II/EOBD diagnostic cable (120 cm)
- ✓ Premium transport case
- ✓ Power adapter (UK/US/EU) & USB Type-C cable
- ✓ User manual & quick start guide
- ✓ 2 years of free updates
Expandable with additional modules: Compatible with the BST-360 battery tester and the i-TPMS tire pressure monitoring system (sold separately). Note: Not compatible with vehicles equipped with a Security Gateway (SGW).
ORIGINAL LAUNCH TECHNOLOGIE
As an official manufacturer, we offer you workshop-quality diagnostic technology without any detours. Since 2003, we have been developing complete solutions that come directly from the developer to you – with a full warranty and German support.
Fragen zum Produkt?
Unser Experten-Support antwortet.